RS Pro 137-2292 Manuel D'utilisation page 7

Troubleshooting
Fault
LCD - No display
Cannot melt solder
Suction ability is low
Unable to absorb
solder
Tin absorption hole
blocked, cannot be
dredged
Remove solder waste
1. Pull the lever up "A" and the holder "B"
31.07.2020, Versions-Nr. 002
LCD DESOLDERING STATION/English
Failure cause
Fail to connect power
source
Fuse blown
Unreasonable setting of
temperature
Nozzle oxidation
Blow - by
Excessive solder waste
storage in glass tube
Filter degradation
Solder hole blocked
Solder insufficiently hot
enough
Solder waste
accumulate at the end of
heating element
A
1. up
Solution
Check the power cord connection and
plug in the power cord to power Jack.
Replace fuse: 3.15A / 250V
Reset the appropriate temperature
Replace nozzle
Check the connection of vacuum outlet
Check the installation of glass tube
Removing solder waste from glass
tube
Replacement of filter
Under heating condition, use cleaning
pin to clean heating element
Ensure heat setting is correct and
allow time to melt solder
Take off the glass tube, use the
soldering iron to heat the steel pipe
back to remove the solder waste, and
then use the cleaning pin to dredge
B
Pull
6