RS Pro 137-2292 Manuel D'utilisation page 6

LCD DESOLDERING STATION/English
Warnings
1. To avoid injury or damage; do not touch metallic parts near the nozzle, do not
use this system near flammable items.
1. Ensure power is off and unplugged before performing any maintenance
procedure, except during the cleaning process of the nozzle and heating element.
3. If the pump does not operate, immediately clean the nozzle & heating element,
and replace the filter
4. At high temperatures, the solder waste will become oxidized (lead free solder's
melting point is 220°C, non-lead-free solder's melting point is 180°C), swelled
and stuck tightly on the inner wall. If it is not cleaned after use, the solder waste
will block the desoldering gun and will not be able to be removed even with
cleaning pin.
Instructions
1. After each operation is finished, immediately trigger the gun to activate the
vacuum pump in free air 3-5 times, this can clean the older waste from inside
the pipe.
2. If used for more than 20 minutes continuously repeat 1. Along with using the
cleaning tool.
3. When you find the desoldering efficiency gets down, please use the cleaning
pin to clean the pipe immediately.
4. If the operation interval is long, we advise to adjust the temperature to about
200°C. When you use it again, you can adjust to the working temperature.
5. When the glass tube has absorbed about 1/2 solder waste, please clean it
immediately. When you find the filter is getting hardened, please replace the
filter immediately.
5
(Cleaning pin)
31.07.2020, Versions-Nr. 002