Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TROLLEY MOUNTING AND INSTALLATION
•
Follow the mounting instructions supplied with
the trolley to install the welding unit, compact
or with separate wire feeder and the cooling
unit.
HOSEPACK CONNECTION
•
Connect the plugs of the interconnecting ho-
sepack to the Positive Sockets -
side of wire feeder and power generator.
•
Connect the military connectors of the inter-
connecting hosepack to the Sockets -
the back side of wire feeder and power gene-
rator.
•
Connect the blue water feed hose of the in-
terconnecting hosepack to the connections
marked in blue -
feeder and water cooler.
•
Connect the red water feed hose of the in-
terconnecting hosepack to the connections
marked in red -
feeder and water cooler.
•
Load the wire, connect the gas cylinder and
replace the flexible if necessary, as described
in this paragraph.
•
Check line voltage and connect power cable.
•
Check the level of coolant in the cooling unit
and turn it on.
•
Power the welding unit ON. The display shows
the screen of the last welding process perfor-
med by the unit.
EARTH CABLE AND TORCH CABLE
CONNECTION
Ensure unit is powered off and unpluged
from the mains.
Figure 1 - Voltage Change
ASSEMBLY
- on the back
J
- on the back side of wire
O
- on the back side of wire
O
PREPARATION FOR WELDING
WATER COOLER CONNECTION
Important: read also the Operating instruc-
tions supplied with the water cooler before
connecting it to the welding unit.
•
Connect the power cable and the pressostat
cable connector to the connector on the back
panel of the unit located inside the com-
partment -
Important: The water cooler is activated
- on
I
from the menu "Basic Setup". Refer to "Ba-
sic Setup" section.
NO-GAS WELDING (MOG)
•
Connect the earth cable to the positive cur-
rent socket – B – of the power source.
•
Connect the torch connection cable to the ne-
gative socket on the Voltage change board
on the horizontal internal panel.
GAS WELDING (MAG)
•
Connect the earth cable to the negative cur-
rent socket – E – of the power source.
•
Connect the torch connection cable to the po-
sitive socket on the Voltage change board on
the horizontal internal panel.
•
Plug the torch hose into the socket – A –
on the front of the welder having care to not
damage the contacts and secure by hand
screwing in the threaded connection.
EN-5
- .
R
Publicité
Table des Matières
