Cutting Hair - Grundig MT 8240 WET&DRY Mode D'emploi

OPERATION ______________________________
Cutting hair
Please use the ceramic/stainless steel
A
cutting head (width 38 mm).
1 If necessary, remove the attachment
by pressing in both side catches
and lifting off.
2
Insert ceramic/stainless steel cutting
A
head carefully at the top and
press down until it clicks into place.
3
Place a towel around the neck and
shoulders of the person whose hair
you are trimming.
4
Make sure the person is seated so
that their head is roughly at your eye
level. Before trimming, comb the hair
so that it falls naturally and you can
see the direction in which it grows.
5
Press the
appliance and start cutting your hair.
6
Press the
appliance after use.
Beard trimming
Please use the beard trimming attach-
7
ment (width 30 mm).
B
1
If necessary, remove the attachment
by pressing in both side catches
and lifting off.
2 Insert beard trimming attachment
carefully at the top and press down
until it clicks into place.
3 Loosen the beard hair by combing
the beard in the direction the hair
grows.
4
Press the
appliance and start trimming your
beard.
5
Press the
appliance after use.
C button to switch on the
C
button to switch off the
C
button to switch on the
C
button to switch off the
ENGLISH
B
7
27