Dyna-Glo DGP350NP Manuel De L'utilisateur Et Instructions D'utilisation page 21

CHECKING FOR LEAKS
After all connections are made, check all connections and fittings on the LP gas tank valve,
gas hose and regulator for leaks with a water and soap solution.
To prevent fire or explosion while testing for a leak:

Always perform leak test prior to lighting the grill.

Do not smoke while testing for a leak.

Always perform leak tests outdoors in a well ventilated area.

Do not use any source of flame while testing for leaks.

Do not use the grill until any and all leaks are corrected.

If you are unable to correct a leak, disconnect the propane supply
and call a gas appliance service dealer.
PERFORM LEAK TEST

Prepare leak test solution by combining 1 part liquid dish soap with 3 parts water.
Total solution required is approximately 2-3 oz. (70-90ml.).
Put leak test solution in a spray bottle.

Ensure all control knobs are in the 'OFF' position.

Open LP gas tank valve.

Spray leak test solution on all gas carrying connections and fittings.
Presence of bubbles at areas of applied test solution indicates a gas leak.
If leaks are detected or you smell or hear gas, shut off the LP gas tank
immediately and repair or replace the defective part.
Do not use the grill until all leaks are corrected.
LP Gas Grill
ASSEMBLY INSTRUCTIONS
19