Dyna-Glo DGE530GSP Mode D'emploi page 16

ASSEMBLY INSTRUCTIONS
15. Insert 1 M6x12 screw (AA) Screw and
2 M4x12 Screws (DD) to grill body (C1),
leaving 4-6mm clearance from screw head to
grill body (C1). Align right side table assembly
(Z) to the 3 inserted screws. Insert 3 M6x12
screws (AA) with plain washers (BB) from the
holes of grill body (C1) out to the right side
table assembly (Z). Secure right side table
assembly (Z) using 1 M4x12 screw (DD).
Adjust the right side table assembly (Z)
correctly then tighten all screws.
Hardware Used
AA
M6x12 Screw
Plain
BB
Washer
DD
M4x12 Screw
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 16.
FAILURE TO DO SO MAY
RESULT IN FIRE OR
EXPLOSION, POSSIBLY
CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
15
DD
x 4
x 3
x 3
16
C1
BB
AA
DD
AA
Z