Dyna-Glo DGE530GSP Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS
9. Secure cylinder exclusion (F) to bottom shelf
(A) and cart rear panel (I) using 2 screws (DD).
Hardware Used
DD M4x12 Screw
10. Carefully place the grill body (C1) onto the cart
left side panel and cart right side panel (H&E).
Adjust the grill body (C1) so that the holes in
the grill body (C1) are aligned with the holes in
the tabs of the cart side panels (H&E).
NOTE: Make sure the gas hose/regulator
assembly is outside the cart. Fasten the grill
body (C1) using 2 screws (AA) and plain
washer (BB) on each side.
Hardware Used
M6x12 Screw
AA
BB
M6 Plain Washer
9
I
F
x 2
10
x 4
x 4
11
DD
A
C1
H
E
BB
AA