Sears CRAFTSMAN 208 CC Manuel Du Propriétaire page 13

Adjusting the Control Cable
Checking the Control Cable
Release the control bar to remove the slack in the control
cable (Figure 20).
Figure 20
1. Control bar
IMPORTANT: The control cable must contain some slack
when you disengage the control bar for the auger blades
to stop properly.
NOTE: You may need to adjust the control cable from
position 1 (default) to position 2 if you notice belt slip
when the control bar is engaged.
NOTE: If the control cable is adjusted to position 2,
ensure that the auger stops properly when the control bar
is released
Adjusting the Control Cable
1. With the control bar disengaged, unhook and move
1
Inspecting the Auger Blades
Before each session, inspect the auger blades for wear.
When a auger blade edge has worn down have an
Authorized Service Dealer replace the auger blades and
the scraper (Figure 22).
13
the control cable to the highest position. (Figure 21).
1
Position 1: Default position
(Lower Hole as shown in illustration)
Figure 21
1. Control bar
2. Adjuster link
3. Cable positions
1
2
Figure 22
1. Auger blades
Position 2
2
3
2. Scraper