Publicité
Les langues disponibles
Les langues disponibles
Water-heating for CDP dehumidifiers,
Installation
The water-heating coil is installed as described below:
Step
1
Remove the two lock screws in the front and lift off the front (4 screws in the
T models)
2
Make two holes in the left-side end (in the right-side end of T-models) and
mount the two rubber sleeves from the box.
NB: Dantherm A/S recommends the use of a subland twist drill in order not
to damage the insulation.
Model
CDP 35/35T
CDP 45/45T
CDP 65
CDP 65T
3
Use the drawings on the next page for this point!
Place the shield and the water-heating coil on the condenser. On the CDP
35T/45T the shield should be turned 180° vertically so that the upright edge
of the shield is hidden behind the water-heating coil.
4
Place the water-heating coil and the shield so that the pre-drilled holes fit
together. Fasten everything to the condenser by the two screws. (The shield
must be placed between the condenser and the water-heating coil).
5
Mount support bushings and angle fittings on the tubes from the bag. Mount
them on the short end (make sure that you pick the right set of tubes from
the bag).
6
Put the tubes through the sleeves from inside and mount them on the tube
ends on the water-heating coil.
continued
Action
A
A
B
30 mm
45 mm
30 mm
45 mm
30 mm
30 mm
30 mm
30 mm
B
C
C
C
Diameter
30 mm
Ø13 mm
30 mm
Ø18 mm
30 mm
Ø22 mm
47 mm
Ø22 mm
Continued overleaf
7
Publicité
