Publicité
Les langues disponibles
Les langues disponibles
Water-heating for CDP dehumidifiers
Introduction
Model
Contents of box
Illustration
Product
description
Continuous fan
operation
Installation
6
This instruction contains all the information you need for the installation of the water-
heating coil.
You will find the technical data on page 15.
The water-heating coil can be used with the following dehumidifiers:
• The CDP 35/45/65 models
• The CDP 35T/45T/65T models
Please check the contents of the box before installation.
The following must be included:
• 1 water-heating coil
• 2 rubber sleeves
• 2 self cutting screws
• 1 shield
This is an illustration of the water-heating coil to be installed:
The water-heating coil is installed in the CDP dehumidifiers for additional heat supply to
the internal air.
To make sure that the heat is supplied to the room, Dantherm recommends that the
fan(s) run continuously.
Continuous fan operation – i.e. independent of the dehumidification – is established
through a bridge between terminal points 25 and 26 on the control.
The water-heating coils are installed differently in the different types of dehumidifier.
The two different procedures are described below.
• 2 angle fittings
• 4 support bushings
• 2 or 4 tubes, see model below:
CDP 35/35T/45/45T:
(2 lefthand/2 right-hand bends).
Choose the tubes (2 pieces) that go
with the dehumidifier in which the
water-heating coil is to be mounted.
CDP 65:
2 tubes
Continued overleaf
Publicité
