Atag Teppan Yaki TY3011M Notice D'utilisation page 127

INSTALLATION INSTRUCTIONS
8. The teppan yaki comes with two sets of rosettes. For this
installation situation you need to use the following rosettes
so that the temperatures are easy to read. Attention: the
rosette with the
rosette with the
F
50
Worktop
9. Press the rosettes from the top onto the pins.
10. Press the control knobs onto the pins.
11. Lead the control box and the mains plug through the cut-
out in the worktop.
12. Position the control box (E) against the positioning plate so
that pin Y falls into hole Z.
13. Turn the teppan yaki over and place it in the cut-out.
14. Place the dripping pan into the teppan yaki.
15. Connect the appliance to the mains. The hob is now ready
for use.
16. Check if the appliance works properly.
17. Give the user manual to your client or, if you own the
teppan yaki, store the manual in a safe place.
EN 31
symbol belongs to the front zone, the
symbol belongs to the rear zone).
R
Top-stone contents
50