Atag Teppan Yaki TY3011M Notice D'utilisation page 119

INSTALLATION INSTRUCTIONS
3. Use the screws supplied to fasten the positioning plate (A)
against the bottom of the worktop so that the holes are
aligned. Use the light rings as fi tting pins.
control knob (2x)
(D)
conical spring (2x)
rosette (2x)
screw (4x)
(B)
light ring (2x)
sealing ring (2x)
pin (2x)
(C)
spring (2x)
(A)
positioning plate (1x)
screw (4x)
hole Y
(E)
control box
nut M4 (2x)
4. When mounting the knobs into the worktop the sealing
rings (B) should be mounted underneath the light rings.
5. Place the light rings (B) from the top through the holes in
the worktop and fasten them from the top with the screws
supplied.
6. Place the springs on the pins (C) and push them from the
bottom through the light rings in the worktop.
7. Place the conical springs on the control knobs (D).
EN 23
Top-wood contents