Atag Teppan Yaki TY3011M Notice D'utilisation page 115

INSTALLATION INSTRUCTIONS
Installation Instruction Top-wood
Before you start
Rear zone
R
Front zone
F
F R
Built-in dimensions
Silicon sealing ring
Thickness worktop < 40 mm
in area P x Q
Attention: the following instruction applies only to an
installation situation whereby the control knobs are in the
worktop, in combination with a "wooden" worktop. See the
"Installation situation table" on page 14.
Choose the right position for the control knobs: in front, to
the left or to the right of the teppan yaki. You can position the
knobs in one of the following ways. This ensures that you can
read the temperature indication on the knob from the user's
position.
R
F
1. The control box can be mounted on worktops with a
maximum thickness of 40 mm. If the worktop at the
position of the control knobs is thicker than 40 mm, refer to
the illustration opposite to create a cut-out in the bottom of
the worktop. Measure the thickness of the worktop and, if
necessary, create this cut-out in the worktop.
67.5 mm
Ø30 mm
Ø2 mm
38 mm
EN 19
Ø30 mm
R2 mm
Ø2 mm
135 mm
P = 270 mm
Top-wood contents
Ø30 mm
Q = 94 mm
Ø2 mm
47 mm