Atag Teppan Yaki TY3011M Notice D'utilisation page 112

INSTALLATION INSTRUCTIONS
If worktop has thickness of:
< 56 mm
> 56 mm
Wooden worktops
Order in which to build in the appliance
x becomes:
x = 51 mm
x = 51 mm + (56 - worktop thickness)
If necessary, treat the sawn ends of wooden worktops with
sealing varnish, to prevent swelling of the worktop by moisture.
1. Turn the appliance upside down and place it on the
worktop. Remove the protective foil from the sealing tape
and apply the tape around the cut-out in the worktop. Start
at the rear side of the appliance and tape the sealing strip
along the corners. Make sure that the ends of the sealing
strip fi t tightly together.
2. Measure the thickness of the kitchen front. Set the control
box to this thickness by correctly positioning the three screws
on the bottom of the control box. The measurements on the
sticker correspond with the thickness of the kitchen front.
3. Position the control box so that the cover of the box faces
10 mm
16 mm
20 mm
32 mm
40 mm
EN 16
contents "Front"
10 mm 10 mm
16 mm 16 mm
20 mm 20 mm
32 mm 32 mm
40 mm 40 mm