TCL TAW Serie Mode D'emploi page 9

Install the support brackets (with sill angle brackets attached) to the bottom of the cabinet as
3.
shown below.
Tighten all 6 bolts securely.
4.
Step 6:
Extend the Accordion Panels
Carefully raise the window to expose the accordion panel and panel frame. Loosen the
1.
locking screws so the accordion panels slide easily.
Extend each panel to completely fill the width of the window. Tighten the locking screws
2.
when the panels are fully extended.
Step 7:
Install the Window Lock and Sash Seal
Trim the sash seal to fit the width of the window. Insert the sash seal into the space between
1.
the upper and lower sashes.
5/8" Long Flat Head Bolt
Hex-Head Screw
Hex-Head Screw
for each support bracket
5/8" Long
Hex-Head Screw
5/8" Long
Hex-Head Screw
1/2" Long
1/2" Long
Window Sash Seal
Window Sash Seal
9
(2) required