Graco LineDriver Serie Manuel page 21

Troubleshooting
PROBLEM
Engine does not start
Engine races to high rpm - stalls
during operation
Engine operates, LineDriver does not
move forward or reverse
Engine operates, LineDriver moves
slowly in forward and reverse
Engine shuts off when operator exits
LineDriver
Engine continues to run when opera-
tor exits LineDriver and parking brake
is not set
Engine misses during turns and for-
ward and reverse changes
Parking brake does not keep Line-
Driver from moving
LineDriver creeps in forward or
reverse direction
Engine light does not turn on
Engine runs for short time and stops Fuel flow restriction
312540J
Operation / Fonctionnement / Funcionamiento / Bediening / Betrieb
CAUSE
Parking brake not engaged. Engine
switch OFF, no gasoline or low oil
Worn governor
Low hydraulic oil
Wheel release is open.
Low hydraulic oil. Parking brake is
set.
Wheel release is open.
Safety switch
Safety switch
Engine oil low
Parking brake needs adjustment
Parking brake needs adjustment
Check light bulb
Check connections
Check Switch position on regulator
SOLUTION
Set Brake. Consult engine manual,
supplied
Consult engine manual, supplied
Fill with Mobil 1 (15W-50) synthetic oil
Close; hand tight.
Fill with Mobil 1 (15W-50) synthetic
oil. Release parking brake.
Close; hand tight.
Set parking brake
Adjust and set parking brake.
Replace safety switch and/or any
connecting wires.
1. Consult engine manual for proper oil
2. Keep engine oil full to avoid nuisance
stalls caused by Oil Alert sensing low oil
levels.
Adjust parking brake
Adjust parking brake
Replace light bulb
Repair connections
Set Switch position on regulator:
1. Set to No Battery if your LineDriver has
no battery
2. Set to Battery if your LineDriver has a bat-
tery
See engine manual
21