Hupfer OTA 47-36 Manuel D'utilisation page 41

Operating instructions
Distance
Adjustment
Fig. 5: Position of the screws
Fig. 6: Remove the rear panel
Open tray dispensers/open sided basket dispensers
2. Measure the distance between the top edge of the tray and the
top edge of the spring case.
< 30 mm 30 to 50 mm
Distance too small: Correctly adjusted
Unhook the tension
springs
CAUTION
Risk of injury
Sharp edges and tension springs may cause injury when hooking and
unhooking the tension springs.
−
Wear protective gloves.
The tension springs in the spring case ensure that the platform for bas-
kets or trays is lowered evenly when items are placed on the platform
for baskets or trays such that the top edge of the item remains at a
constant height. The number of springs hooked on must be adjusted to
the total weight of the items.
Opening the spring case
1. Remove the items from the platform for baskets or trays.
�� The loading platform is in the starting position.
2. Remove the marked screws [1].
3. Lift the rear panel slightly [2]. Use a screwdriver to help if neces-
sary.
4. Tilt the rear panel as shown in the figure [3].
5. Pull the rear panel out in a downward direction [4].
�� The spring case is open and the tension springs are freely
accessible.
NOTICE
Damage to the guide elements
The tension springs must be hooked on symmetrically. If the tension
springs are only hooked on one side, the platform for baskets or trays
will be damaged.
−
Hook or unhook the tension springs equally on the left and right.
6. Always unhook the tension springs from the bottom. Make sure
that the tension springs are symmetrically distributed.
> 50 mm
Distance too large:
Hook on the tension
springs
16 / 24