Pando E200/110 Instructions D'utilisation Et Avis De Montage page 31

Reset of the original factory frequency:
ONLY FOR V.2.0 VERSION REMOTE CONTROLS
To reset the factory configuration, carry out
the following procedure:
press the buttons for two seconds until the
LEDs light up.
Successively, press the following buttons
within 5 seconds.
Six flashes of the LEDs indicate that the op-
eration has been completed.
ATTENTION: After this operation it will be
necessary to carry out the "Learning the
new transmission code" procedure again.
ATTENTION: The battery must be substi-
tuted each year to ensure the optimal ca-
pacity of the transmitter.
To substitute a discharged battery, remove
the plastic cover, remove the used battery
and insert a new 12V 23A alkaline battery
respecting the polarity.
The used battery must be thrown into the
appropriate container.
WARNING:
Changes or modifications not expressly
approved by the possessor of the norm
compatibility certificate may invalidate the
right of the user to utilize the devices.
simultaneously
30
CORIAN VERSION REMOTE CONTROL:
(An optional only for certain models.
Check with the distributor).
1
1. Switching on and off of the engine hood.
2. Reducing motor speed.
3. Increase motor speed.
4. Timer motor, keeps the hood on for 10
minutes, after which it will be switched off.
5. LED pressure indicator button on the re-
mote control. It also indicates processing in
progress.
6. Lights on and off *.
* A short press turns on or off the main light, and
only in models with courtesy light, it can be control-
led with a long press of 2 seconds.
Synchronize the remote control with the
hood:
Once you have installed the hood or if you
make a change the transmission code, you
must synchronize with the remote control
unit of the hood. Procedure: Disconnect and
reconnect the power control unit (control unit
via a switch or plug the hood of the hood,
or through circuit breaker on the electrical
panel home) once reconnected the hood to
the mains within 20 seconds with the remote
control pointed at the hood, press the light
button, the hood will light indicating that the
procedure was successful.
If it takes longer than 20 seconds to synchro-
nize the remote control, the controller will
close the reception and will not record any
code.
Beware: the synchronization of the remote
control with the hood can be lost because
of external reasons, such as power out-
ages, electrical discharges, interference ...
In these cases, repeat the synchronization
process.
2 3 4 5 6