Mounting Module To The P72 And P74 Displays; Setting The Ip Address - Rockwell Automation Allen-Bradley 2706-PENET1 Instructions D'installation

8 InView Ethernet TCP/IP Module

Mounting Module to the P72 and P74 Displays

The P72 and P74 InView displays do not have a track for mounting the module on
the display. You can remove the back plate and mount the bottom of the enclosure
to a wall or panel near the display. Use screws (8-32 UNC-2A) measuring a
minimum of 1/4" plus the thickness of the mounting surface.
The dimensions for the 4 mounting holes are shown below.
Enclosure Case
7.40 in (188 mm)
3.46
(88 mm)

Setting the IP Address

The Ethernet TCP/IP configuration utility is installed as part of the Inview
Messaging Software package. When first opening the Inview Messaging Software,
you are asked to create a display and a message file. After the display is created
you can configure the IP address of the 2706-PENET1 module.
1. Select the display you created, which will use the Ethernet module. Right
click on the display and select Edit Display as shown below.
Publication 2706-IN008D-EN-P - October 2003