Elica EASY EES320SS Manuel D'utilisation page 5

Use
The hood has been made for use in the internal recirculating
filtering version.
Cooking fumes and steam are aspirated inside the hood,
filtered and cleaned, passing through the fat filter/s and the
carbon filter/s that MUST be supplied with the hood.
Installation
Specialised personnel must carry out both the electrical
and the mechanical installation.
Do not cut a joist or stud unless absolutely
necessary. If a joist or stud must be cut, then
a supporting frame must be constructed.
Fittings material is provided to secure the
hood to most types of walls/ceilings.
However, a qualified technician must verify
suitability of the materials in accordance with
the type of wall/ceiling.
Before making cutouts, make sure there is
proper clearance within the ceiling or wall for
exhaust vent.
Hood installation height above cooktop is the
users preference. The lower the hood is
above the cooktop, the more efficient the
capturing of cooking odors, grease and
smoke.
CAUTION:
FOR GAS RANGES
INSTALLATION: MOUNT THIS HOOD SO
THAT THE BOTTOM EDGE IS AT 30" (76,2
CM) ABOVE THE COOKING SURFACE.
FOR ELECTRIC RANGES INSTALLATION:
MOUNT THIS HOOD SO THAT THE
BOTTOM EDGE IS NOT LESS THAN 24"
(61 CM) AND NO MORE THAN 30" (76,2
CM) ABOVE THE COOKING SURFACE.
HOUSEHOLD USE. PLEASE, READ
INSTALLATION MANUAL FOR SPECIFIC
APPLICATION.
Check your ceiling height and the hood
height maximum before you select your
hood.
Consult last pages of this manual for installation
instruction and electrical connection steps.
Operation
T1. Button ON/OFF lights
T2. Button to decrease suction speed (power)
OFF 1: press repeatedly to decrease the speed until you
turn off the hood
OFF 2: at any speed press and hold for a longer time
T3. Button ON/to increasesuction speed (power) (1-2-3-
Intensive) / Timer
Intensive speed has a duration of approx. 5 minutes,
then speed 3 is automatically set.
To program the automatic switch-off (Timer) press and
hold for a longer time; the shutoff time changes according
to the set speed:
Speed 1: 20 minutes
Speed 2: 15 minutes
Speed 3: 10 minutes
Intensive speed: 5 minutes
Filter Saturation Indicator
The hood signals when necessary to perform filter
maintenance:
Grease filter (every 40 hours of use): all Leds with red light
Activated charcoal odour filter (every 160 hours of
operation): all LEDs with red light, LEDs L2 and L3 blink
Reset Filter Saturation
After performing filter maintenance, press and hold buttons T1
and T3, Leds L1, L2 and L3 blink briefly in red and then turn
off for good.
Activation indicator for odour filter saturation with
activated charcoal
This indicator is normally disabled. To enable it, proceed
as follows:
With the hood off, press and hold simultaneously T1
and T2: L1 turns on first, then L2 and L3 and after that,
when the buttons are released, the Leds L2 and L3 flash
briefly to indicate successful activation.
Disabling the LED for charcoal filter
saturation: repeat the operation above; first the LEDs L1, L2
and L3 turn on simultaneously, then only L1, and after that,
when the buttons are released, the leds L1, L2 and L3 turn on
again to indicate successful disabling.
5