Klarstein Silent Service Mode D'emploi page 21

• Do not connect the device to multiple sockets.
• Do not use an extension cable.
• Do not connect the device to timers or remote controlled sockets.
• Do not operate or store the unit near heat sources such as heaters.
• Never immerse the device or the plug in water or other liquids. If water leaks,
disconnect the plug immediately and have the device checked by a specialist
workshop.
• When using the device for the first time, remove all film and all packaging material.
• Do not pull the plug out of the mains socket by the cable, but rather hold it by hand
when removing it.
• Before plugging the plug into the mains, make sure that the device is switched off.
• Do not stretch the power cord.
• Make sure that all air inlets and outlets are clear and not covered so that the unit
does not overheat.
• Make sure that the power cord is not running over sharp edges or surfaces. Do not
hang the unit on the ceiling or wall unless it is designed for this operation
• Allow enough space around the device for walls, furniture, or other equipment to
ensure the best possible performance.
• Do not use the device near gas ovens or gas heaters.
• Always unplug the device, before you clean or maintain it.
• Do not use the device near explosive or flammable substances or liquids.
Special safety instructions
• The fan base mounting bracket can support a load of 34.5 kg.
• The fan is to installed so that the blades are more than 2.3 m above the door and
the blades distance to wall min 0.6 m.
• The mounting of the suspension system shall be performed by the manufacturer, its
service agent or suitably qualified persons.
• An all-pole disconnector with isolating distance of 3 mm must be incorporated in
the fixed wiring in accordance with the national wiring rules.
• This product is in accordance with safety standards into force. Repairs should be
exclusively performed by qualified technicians using original spare parts. Any
breach of this instruction may be particularly dangerous for the users.
EN
21