Important Safety Information; Speaker Placement; Packing List - Klipsch ProMedia 2.1 Manuel Du Propriétaire

IMPORTANT SAFETY INFORMATION

1. READ these instructions.
2. KEEP these instructions.
3. HEED all warnings.
4. FOLLOW all instructions.
5. DO NOT use this apparatus near water.
6. CLEAN ONLY with dry cloth.
7. DO NOT block any ventilation openings. Install in accordance with the manufacturer's instructions.
8. DO NOT install near any heat sources such as radiators, heat registers, stoves, or other ap-
paratus (including amplifiers) that produce heat.
9. DO NOT defeat the safety purpose of the polarized or grounding type plug. A polarized plug has
two blades with one wider than the other. A grounding type plug has two blades and a third
grounding prong. The wider blade or the third prong is provided for your safety. If the provided
plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11. ONLY USE attachments/accessories specified by the manufacturer.
12. USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
13. UNPLUG this apparatus during lightning storms or when unused for long periods of time.
14. REFER all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as the power-supply cord or plug is damaged, liquid has
been spilled, objects have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
15. DO NOT expose this apparatus to dripping or splashing and ensure that no objects filled with
liquids, such as vases, are placed on the apparatus.
16. To completely disconnect this apparatus from the AC mains, disconnect the power supply cord
plug from the AC receptacle.
17. The mains plug of the power supply cord shall remain readily operable.
The exclamation point, within an equilateral triangle, is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the product.
The lightning flash with arrowhead symbol within an equilateral triangle, is intended
to alert the user to the presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude to constitute a risk of
electrical shock to persons.
WARNING: To reduce the risk of fire or electrical shock, do not expose this apparatus to rain or moisture.
WARNING: No naked flame sources – such as candles – should be placed on the product.
RISK OF ELECTRIC SHOCK.
WARNING: Do Not Open! Risk of Electrical Shock. Voltages in this
equipment are hazardous to life. No user-serviceable parts inside.
Refer all servicing to qualified service personnel.
WARNING: This product is intended to be operated ONLY from the AC Voltages listed on the back
panel or included power supply of the product. Operation from voltages other than those indicated
may cause irreversible damage to the product and void the product's warranty. The use of AC
Plug Adapters is cautioned because it can allow the product to be plugged into voltages in which
the product was not designed to operate. If the product is equipped with a detachable power cord,
use only the type provided with your product or by your local distributor and/or retailer. If you are
unsure of the correct operational voltage, please contact your local distributor and/or retailer.
CAUTION: Place the equipment near a main power supply outlet and make sure that you can
easily access the power breaker switch.

PACKING LIST

2 Satellite speakers with pedestals and wires attached
1 Control pod, attached to one satellite speaker
1 Subwoofer
1 Packet of rubber isolation feet
1 Owner's manual
W A R N I N G
DO NOT OPEN.

SPEAKER PLACEMENT

1. The two satellite speakers should be positioned on each side of your
computer monitor. To wall mount, the pedestal stands may be removed by
unscrewing the 1/4" 20-thread bolt, which accommodates a wide variety of
wall brackets available through stereo and appliance stores.
2. Place the subwoofer under your computer desk. The subwoofer must be
placed on the floor near a wall with the rear panel toward the wall. Do not
cover up the sub driver or front port of the enclosure and be sure to provide
enough ventilation to the rear of the subwoofer. It is normal for this panel to
be warm to the touch. The subwoofer should be at least 3 feet (1m) from the
computer monitor to avoid interference.
3. Speaker or power cables running across an area of heavy foot traffic should be
positioned against a wall or corner and secured with tape.
SPEAKER CONNECTION DIAGRAM
1. Do not plug in the AC power cord until your computer/audio system is set up.
2. Connect mini plug to PC soundcard from the control satellite preamp. Care
should be advised concerning the cables at back of sub. Bumping them could
cause damage.
3. Connect the DIN plug to the sub from the control satellite preamp.
4. Connect the speakers by inserting the tinned wire leads into the subwoofer.
The solid black wires (-) connect to the black spring clips; the black wires
with red stripes (+) to the red spring clips.
5. Plug the AC power cord into a wall outlet.
6. Plug headphone mini stereo plug in headphone jack, if desired.
7. Plug stereo mini plug into MP3/Aux jack. Plug stereo mini plug into MP3
player (for example).
Since the ProMedia 2.1 has its own internal amplifier, it was designed to use
the "line out" connector of the computer. Connection to the speaker level output
jack might result in poor sound quality.
SOFTWARE AND HARDWARE GAIN CONTROLS
Software Volume Controls in Microsoft Windows
1. Click the Start button on your taskbar
2. Choose Accessories
3. Windows 95: Choose Multimedia
Windows 98/2000/XP/Vista/7: Choose Entertainment
4. Click on the Volume Control
5. Adjust the Wave Volume Elevator Button to 70%
Volume Control Programs
Some soundcard and/or PC manufacturers may have software that must be
adjusted separately from the Windows volume control. Consult applicable
manual for specific hardware documentation.
230 V