Publicité
8
PLACE THE TOWERS AND BARS.
Place the towers and
bars onto the Landing
Pads making sure
they are fully seated.
9
CENTER THE CROSSBARS.
Measure and adjust
the crossbar so that
the overhang on
each side is even.
10
LEVEL THE CROSSBARS.
Hold the crossbar level, then tighten the
adjustment screw on the face of each tower
with the torque wrench to 3.5Nm as shown.
0°
Instruction #1036022A-Page 4 of 10
X
"Click"
"Click"
"Click"
"Clic"
"Clic"
"Clic"
X=X
11
3.5Nm
4X
X
TIGHTEN LANDING PADS.
Remove the crossbars, then use
the 5 mm wrench to fully tighten
the Landing Pads to 2.5Nm.
2.5Nm
2X
2X
8X
Publicité
