How To Use - Assa Abloy EMTEK LISCIO Guide D'installation

How to Use

Lever buttons
Keyed Cylinder
Using the Lock
Once installed on door with the battery connected - your lock is ready for use.
Factory Default Setting
User & Master Codes are labeled on the inside trim plate and back cover page.
Entering User Codes
• Entering a correct, active user code (green LED x1 & beep x1) - unlocks
• Entering an incorrect or inactive code (red LED x2 & beep x2) - remains locked
• Three incorrect entries will result in lockout, signaled by 3 red LED flashes
& 3 short beeps, lockout lasts for 30 seconds.
To Restart Code Entry
Press and hold #1 button for three seconds (this works in entry or programming mode).
Key Access
Lock may also be unlocked and locked via keyed cylinder, each lock comes with two keys.
Passage & Privacy Mode
Use inside thumbturn.
Setting Setting Description
Thumbturn
Lock access is regulated. A correct, active user code is required for
Enable ON
access. (Privacy Mode)
Thumbturn
Lock access in NOT regulated. Always Unlocked (Passage Mode)
Enable OFF
Your Lock is Ready to Use
Thumbturn Position
Thumbturn
LED Feedback
Green
Amber
EN EN
9