To Fill The Gun With A Filler Pump; To Fill The Gun From Bulk Container - Lincoln 1400 Mode D'emploi

Model 1400, 1440, 1442, 1442E, 1444, 1444E
PowerLuber Grease Gun
4. Remove the pull tab from grease cartridge
and screw grease tube assembly into
pump assembly.
5. Release follower rod from slot. Purge air
from pump. See air purging instructions.
TO CONVERT GUN TO ALLOW
FILLING FROM BULK CONTAINER
OR FILLER PUMP
1. Unscrew the grease tube assembly cap
from the grease tube assembly. Pull on the
follower handle to extract the follower and
spring from the grease tube assembly.
2. Grasp follower between thumb and forefin-
ger and flip the follower lip from the rear to
the front side.
NOTE. The follower resembles a cup. When
the gun is assembled for use with bulk
lubricant, the cup opens toward the pump
assembly.
3. Reassemble follower into grease tube
assembly and position with the follower
handle so that the grease tube assembly
cap can be tightened onto the container
tube.
Figure 2
TO FILL THE GUN FROM BULK
CONTAINER
1. Remove pump assembly from grease tube
assembly.
2. Pack lubricant into cavity of the pump as-
sembly.
3. Insert the open end of the grease tube
assembly into lubricant. Slowly pull the fol-
lower handle back while pushing the grease
tube assembly deeper into the lubricant to
prevent air pockets from being pulled into
the grease tube assembly.
4. When the follower rod is fully extended, pull
it sideways to latch the rod groove into the
keyhole slot in the grease tube assembly
cap.
5. Loosely assemble the pump assembly to the
grease tube assembly. Release the follower
rod from the grease tube assembly cap and
disengage the follower rod from the follower
by rotating the follower handle. Push the
follower rod into the grease tube assembly.
Page Number - 6
Slowly unscrew the grease tube assembly
from the pump assembly until lubricant
oozes from the interface. Tighten grease
tube assembly into the pump assembly.
Figure 3
TO FILL THE GUN WITH A FILLER
PUMP
Engage the follower rod with the follower by
rotating the follower handle. Insert the gun
vent/bulk fill valve into the filler pump socket.
Operate the filler pump to fill the container.
When the follower rod groove is exposed, the
grease tube assembly is filled. The follower rod
will be extended approximately 8 inches (20
cm). Disengage the follower rod from the fol-
lower by rotating the follower handle. Push the
follower rod into the grease tube assembly.
Figure 4
Form 402103