Initial Programming - CAME 001DC01EARY Mode D'emploi

Connection example M
M
001DC002AC
NO
Programming
The kit is pre-configured to manage a single call originating from a single entry panel. One or more receivers answering the same call can be added, by
following the below "Call button programming" procedure.

Initial programming

>3''
<6''
PROG
a
SW3



10
M1 M2
– +
C
B
B
–
VLS/300
001DC005AC
Entering Programming Mode. Press the PROG a key for at least 3 seconds and then release it
(within 6 seconds), as soon as the LED PROG lights up and the key back lighting flashes as illustrated
in figure . Failure of the PROG LED to light up, indicates a malfunction. Check the connections and
re-access the programming mode.
Programming of the Key Type. Press the first key of the entry panel in the position indicated /
A until the backlighting LED stops flashing  and remains lit.
PROG

M1
SW3
BOUT
Programming the call keys. Lift the receiver (if present) of the extension that you want to programme
 then press the door lock release
key to associate with the internal extension : an acoustic signal will confirm that the setting was
PROG
stored. Hang up the receiver again, if necessary  and continue, repeating the same operations for
the other extensions.
SW3

M1
– +
BOUT
PROG
SW3
M2
and AUX2  buttons. On the entry panel, press the call
M2
 A
M1
BOUT
beep

001CK0010-14FR-15FR 24810650 05-08-14_EN
PROG
SW3
PROG
SW3
M2