Inserting The Bobbin - Singer 5560 Manuel D'instruction

2
GETTING READY TO SEW

Inserting the Bobbin

⚠
Turn power switch off before inserting or removing the bobbin.
A
→
The bobbin case must be properly seated into the holder or the machine will not sew. After placing
it into the holder and releasing the tab, if the bobbin case seems loose, if it falls to one side, or if it is not
pushed all the way in, remove it. Hold it by the latch and reinsert it until it is securely in place.
12
1. Take off the removable storage compartment.
2. Open the hinged cover.
3. Pull the bobbin case latch to remove the bobbin case
from the bobbin holder.
4. Hold the bobbin case in one hand, then insert the bobbin
so that the thread runs clockwise, as shown in the
illustration.
5. First, bring the thread into the small slit (A) on the side
of the bobbin case. Then, bring it underneath the metal
guide, continuing until it is comes out of the opening at
the bottom of the metal guide. You should feel it and
hear it click in place. If it does not click in place, the
machine will not sew. After clicking the thread in place,
pull the thread in the direction shown (B).
B
6. Once the bobbin has been placed in the bobbin case,
hold the bobbin case by the latch so that the latch is
pointing toward you. Insert into the bobbin case holder
so that the metal extension is positioned at 12 o'clock.
You should feel the bobbin case become seated
securely in place. Release the latch.