Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Identify the (3) mounting locations for each bracket by looking under the driver side of the vehicle. Note the existing factory installed
studs. Use a wire brush or thread chaser die to remove excess paint or undercoating from threaded studs as necessary.
1
2
Beginning with the front bracket, install a washer and a Nylock locknut at each mounting location. Hand tighten only at this
3
NOTE: Actual application may vary slightly from illustrations.
Front driver side shown
Align front nerf bar bracket with studs. (Front bracket shown.)
point. Repeat for rear mounting location.
Figure 1
Figure 2
Figure 3
Page 2 of 3
Publicité
Table des Matières
