Preparation - Dyna-Glo DGA550SSN Mode D'emploi

SAFETY INFORMATION
• DO NOT touch metal parts of grill until it has completely cooled (about 45 minutes) to avoid burns,
unless you are wearing protective gear (pot holders, gloves, BBQ mittens, etc...).
• DO NOT alter this grill in any manner.
• Clean and inspect the hose before each use. If there is evidence of abrasion, wear, cuts, or leaks,
the hose must be replaced prior to operating the appliance. The replacement hose assembly will be
that which is specified by the manufacturer, listed in the repair parts list in this manual.
• Move gas hoses as far away as possible from hot surfaces and dripping hot grease.
• Keep the grill's valve compartment, burners and circulating air passages clean. Inspect the grill
before each use. Do not obstruct the flow of gas or ventilation air.
• The use of alcohol, prescription or non-prescription drugs may impair the operator's ability to properly
assemble or safely operate the grill.
• DO NOT leave a lit grill unattended. Keep children and pets away from the grill at all times.
• DO NOT place this grill on any type of tabletop surface. The grill should be placed on a flat and level
surface.
• DO NOT use the grill in high winds.

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 50 minutes with two people
Tools Required for Assembly and leak testing (not included): Phillips screwdriver, spray bottle.
7