Dyna-Glo DGA550SSN Mode D'emploi page 14

ASSEMBLY INSTRUCTIONS
19. Align the key holes on the burner tray with the
side burner cooking grate (Q) and set in place.
20. Partially insert two M6x16 screws (FF) into the
right side of grill body (O). DO NOT fully tighten
screws (leave approximately 5 mm).
Hardware Used
FF
M6x16 Screw
21. Align the key holes in the right shelf (R) with the
two screws (FF) just installed in the grill body (O)
and tighten screws. Insert three M6x16 screws
(FF) in the remaining holes in the supports and
tighten.
Hardware Used
FF
M6x16 Screw
19
Q
20
x 2
21
x 3
14
O
FF
R
FF
O