Dyna-Glo DGA550SSN Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS
10. Remove preassembled M6x25 screws (HH)
from the lid handle (U). Attach the lid handle (U)
by inserting two M6x25 screws (HH) from inside
the lid of the grill body (O), through the lid handle
bezels (V), into the lid handle (U) and tightening
securely.
Hardware Used
HH
M6x25 Screw
11. Slip main burner control knobs (M) and side/
rear burner control knobs (N) onto the valve
stems located on the front control panel of the
grill body (O).
12. Lock the back two locking casters (B) to ensure
the cart does not move. Using two people,
carefully place the grill body (O) over the
mounting tabs on the cart side panels (D & E)
and onto the cart. Adjust the grill body (O) so that
the holes in the grill body (O) are aligned with the
holes in the tabs of the cart side panels (D & E).
NOTE: Make sure the natural gas hose is inside
the cart and exits through the opening hole in the
cart rear panel (F).
10
1
x 2
11
O
N
12
O
D
11
U
V
1
HH
M
F
O
E