Dyna-Glo DGO1176BDC-D Mode D'emploi page 7

ASSEMBLY INSTRUCTIONS
CAUTION: This unit is HEAVY! Do not attempt
3.
this step without assistance!
With the assistance of a helper, stand the unit up
right on its legs on a firm and level surface. (Make
sure that legs are wellattached). Place both doors
back onto the smoker body. Position the square
smoke stack (A) with control arm to the left as
shown. Using 4 bolts (AA), attach square smoke
stack (A) to the top of smoker body (G). Securely
tighten with a Phillips screwdriver.
Hardware Used
AA M6 x 12mm
Screw
4. Attach lifting handle (B) to smoker body-left (G)
using four M6x12 screws (AA).
Hardware Used
M6 x 12mm
AA
Screw
5. Attach door handle bracket (K) to smoker
body-left (G) using two M6x12 screws (AA).
Hardware Used
AA M6 x 12mm
Screw
x 4
x 4
x 2
7
3
A
4
G
B
AA
5
AA
G
G
K
AA