Electrical Safety; After Use - Metro HSC2360 Traduction De La Notice Originale

appliance require special
disposal procedures. When
disposing of them, please
consult your service agent or a
similarly qualified person.
41. Do not place heavy objects or
objects filled with water, e.g.
vases, on the appliance.
42. Keep a minimum distance of
1m between the appliance
and walls or other objects.
If the distance is too small,
the cooling capacity may be
impacted.
43. Do not use excessive force to
open the glass door and do not
apply pressure to the glass to
prevent it from breaking.
44. After turning the appliance off,
always wait at least 5 minutes
until turning it on again.
Otherwise, the compressor
may be damaged.
45. The appliance is very heavy.
It is recommended to slide
the appliance for transport
whenever possible. If the
appliance must be lifted, please
only do so with specialized
equipment or have it lifted by
qualified professionals.
46. Important! Allow the appliance
to stand upright for at least 8
hours before connecting it to a
mains outlet for the first time,
so that the refrigerant can
settle.
47. Please double check and
confirm there is no person
inside the appliance before
locking the door.

Electrical safety

1. Ensure the rated voltage shown
on the rating label corresponds
with the voltage of the power
supply.
2. Do not operate any appliance
with a damaged power
cord or plug, when the
appliance malfunctions or has
been damaged in any manner.
3. Protect the power cord against
damages. Do not let it hang
over sharp edges, do not
squeeze or bend it. Keep
the power cord away from
hot surfaces and ensure that
nobody can trip over it.
4. Do not insert fingers or foreign
objects in any opening of the
appliance and do not obstruct
the air vents.
5. Protect the appliance against
heat. Do not place close to
heat sources such as stoves or
heating appliances.

3. After use

Cleaning
• Switch off and unplug the appliance before
cleaning or maintenance.
• Do not clean the appliance with steel wool,
strong chemicals, alkali, abrasive or toxic
agents, as they may damage the surface of the
appliance and pose a health hazard.
• During cleaning, do not approach sharp
elements (evaporator, condenser, etc.) that
could cause cutting injuries bare-handed.
Always use protective gloves.
• Use little or no water during cleaning. Make
sure that no water enters the appliance while
cleaning it.
- 5 -
GB