Installation Procedure; Preparation For Installation; Unpack The Device - Berbel Ergoline 2 Manuel D'utilisation Et De Montage

Installation
3.5

Installation procedure

Short overview:

1. Preparation for installation

2. Unpack the device

3. Remove the lower section and Capillar Trap
4. Hang the device in place
5. Connect accessories
6. Install filter (with recirculating and hybrid operation)
7. Connect exhaust air ducting (with exhausted air and
hybrid operation)
8. Establish electrical power supply
9. Mounting the chimney
10. Insert the capillar trap and lower section
11. Check and carry out commissioning
3.5.1 Preparation for installation
Familiarise yourself with the installation situation and the
associated documents.
Device and instructions.
Accessories.
Installation location.
Intended operating mode.
Assemble the tools and materials required:
Stable stepladder
Folding rule or measuring tape
Pencil
Spirit level
Slotted screwdriver SL 2.5 x 0.4
Torx screwdriver TX30
Ø 8 mm masonry bit
Hammer drill
10 mm spanner
Protective material (e.g. thick cardboard) for the hob
and the worktops
Keep the installation area free of objects that could be in
the way or that could be damaged.
Make sure that the hob and other parts that could be
touched have cooled down.
Protect the hob and other surfaces in the installation area
(e.g. with thick cardboard).
Ensure that the power supply is switched off and remains
so. Connect the power supply only when instructed to do
so in the installation instructions.
If accessories (e.g. wall box, window contact switch) are
required for the installation:
Observe the instructions for the accessories.
Ensure that the accessories are correctly installed and
ready for connection.
Ensure that the connection cables from accessories are
correctly routed and accessible.
130
3.5.2 Unpack the device
ATTENTION!
Hazard of glass breaking or other damage due to
incorrect handling!
The device and its surfaces can be damaged when being
unpacked or transported.
Do not cut into the protective cardboard packaging.
Keep objects that could scratch the device far away from
it (e.g. tools, belt buckles).
Unpack the device and all accompanying parts carefully.
Place the device on its back on a firm, clean and
protective surface (e.g. thick cardboard).
Check the device and its constituent parts for damage.
Check the delivery is complete.
"2.4 Scope of delivery" (page 127).
If parts are missing or damaged:
Please consult your dealer or customer services.
Remove the packaging material.
"8.1 Dispose of packaging" (page 149).
6003396_a – 27.03.2017