TAD M1000 Mode D'emploi page 8

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
Rear panel
3. SPEAKER R terminals
Connect speakers with rated impedance of 4 Ω to 16 Ω.
4. INPUT R terminals (BALANCED/UNBALANCED)
Connect to Pre-Amplifier.
5. BALANCED/UNBALANCED input connector selector
switch
In accordance with the type of output connectors for the
Pre-Amplifier to be connected, set this selector switch to
either BALANCED (XLR-3-31) or UNBALANCED (RCA pin
jack).
6. BI-AMP Switch
Connect BI-AMP using 2 power amplifiers.
7. INPUT L terminals (BALANCED/UNBALANCED)
Connect to Pre-Amplifier.
8. SPEAKER L terminals
Connect speakers with impedance of 4 Ω to 16 Ω.
8
3
4
INPUT R
BALANCED
UNBALANCED
SPEAKER R
5
7
8
INPUT L
UNBALANCED
BALANCED
UNBALANCED
BALANCED
SPEAKER L
BI-AMP
STEREO
6
9. 12V TRIGGER IN connector
This terminal can be used to switch unit power on/standby
from an external component.
Input connector: Ø 3.5 mm monaural mini-jack
Operating specifications:
When in the standby mode, if the input signal voltage
changes from L to H ................................ power on mode
When in power on mode, if the input signal voltage
changes from H to L ................................... standby mode
When H level signal is being input to the 12V TRIGGER
INPUT connector, the main unit's power switch cannot
be used to turn the power off.
10. AUTO POWER DOWN switch (ON/OFF)
When this switch is set to ON, the unit will automatically
enter the standby mode after about three hours. When set
to OFF, the function is disabled.
11. AC IN connector
Connect the accessory power cord here.
9
10
11
12 V
AUTO
TRIGGER IN
POWER DOWN
ON OFF
AC IN

Publicité

Table des Matières
loading

Produits Connexes pour TAD M1000

Table des Matières