Warning Symbols - BGS technic 1609 Mode D'emploi

SAFETY INFORMATIONS
•
Always wear safety goggles and gloves when working with hydraulic pump.
•
Make sure that hose couplings are all properly connected.
•
Avoid skin and eye contact with hydraulic oil. Should hydraulic oil get into eyes or wounds
despite all precautionary measures, remove the oil immediately and consult a doctor.
•
Before each use, check the hose lines and the device for damage.
•
Do not use the hydraulic pump if the hose line, hose coupling or the hydraulic pump itself is
defective. The hydraulic pump may only be used again after it has been repaired.
•
Failure to comply with the aforementioned safety information can result in severe injuries and /
or property damage.

WARNING SYMBOLS

Do not remove any type plates or warning notices; these must remain clearly visible and clean on the
hydraulic pump.
RESPONSIBILITY
The owner / operator is responsible for the maintenance, care and legibility of all warning signs and
the operating instructions that contribute to the safe operation of the hydraulic tool. Read all safety
warnings and instructions. Make sure that all safety instructions are understood before use. The
hydraulic tool must be checked for visible damage before each use. If damage is found, the hydraulic
tool may only be put back into operation after repairs have been carried out.
COMPONENTS
1 Oil outlet
2 Ventilation valve
3 Oil tank
4 Air inlet
A Pressure release pedal
B Pressure build-up pedal
PREPARATION
•
In order to prevent leakage during transport, the ventilation valve (2) must be closed during
transport. Before use, open the ventilation valve by turning it counterclockwise (approx. one turn).
•
Always secure threaded port connections with non-hardening pipe thread compound. Tighten
securely to prevent accidental removal of components while in use. Take care not to introduce
compound into port orifices.
•
Familiarize yourself with the technical details and the illustrations in these operating instructions.
Get to know the hydraulic pump and how it works before you use it.
•
Details on thread sizes and usable oil volume can be found in the "Technical data" chapter.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed