Preparing The Multi Cradle And Power Supply; Multi Cradle (Ac Adaptor) - Panasonic DVD-LX9 Mode D'emploi

Preparing the multi cradle and power supply

BEFORE USE
Remove the
insulation sheet
DC IN 9V
Make sure the built-in battery is attached
whenever you use the unit.

Multi cradle (AC adaptor)

1
Unwind speaker wire,
then fit the wire back
into the groove of the
speaker base.
2
Twist and pull off the vinyl tip.
3
Connect the speakers.
COMPONENT VIDEO OUT S VIDEO AUDIO OUT 5.1ch VIDEO
OUT OUT
+ (480P/480I) SUB 2ch (MIX) +
SPEAKER Y P B R P WOOFER CENTER SORROUND FRONT SPEAKER
HAUT HAUT
PARLEUR PARLEUR
4≠ 4≠
R - - L
R L R L
Push the levers and insert the wires.
Light gray
No line
Black line
Dark gray
Caution
Use the speakers only with
the recommended system.
Failure to do so may lead to
damage to the connected
equipment and/or the
speakers, and may result in
the risk of fire. Consult a
qualified service person if
damage has occurred or if
you experience a sudden
change in performance.
12
4
Attach to cradle.
(When the unit is off)
Make sure built-in battery
is attached.
Ë
DC IN 9V
DC IN
DC IN
Household AC outlet
(AC 120 V, 60 Hz)
When using only the player
Connect the AC adaptor directly to the player's
DC IN terminal.
The unit is in the standby condition (the [Í]
indicator lights) when the AC power supply
cord is connected. The primary circuit is
always "live" as long as the AC adaptor is
connected to an electrical outlet.
≥To conserve power
When the unit is not going to be used for a long
time, disconnect the AC power supply cord from
the AC outlet.
The unit consumes a small amount of power
(approx. 0.9 W, when in the multi cradle) when
in standby mode.
∫ To detach
(When the unit is off)
VIDEO AUDIO
SD CARD : PUSH RELEASE OPT OUT
RELEASE
Pull the lever so the unit lifts off the cradle.
Battery pack (Lithium ion battery pack)
≥Charge the battery pack before using it for the
first time.
≥Use together with the optional battery pack
(➡ page 14) for longer play.
1
≥For replacement (➡ page 4)
2 ∫ To recharge
Fit so unit
clicks firmly
(When the unit is off)
∫
into place.
Attach the unit to the multi cradle (➡ left).
≥You can also connect the AC adaptor directly
to the player to recharge the battery.
[Recharging]
CHG
[CHG] lights
[Í] goes out
Recharging is complete when [CHG] goes
out. ([Í] lights.)
∫ Recharging and play times
Times shown are approximate. Actual times
depend on operating conditions.
Recharging [at 20 oC (68 oF)]: 4 (13) hours
Play (in hours, at room temperature, using
headphones)
LCD brightness level
j5
DVD 2.5 (7.5)
SD 3 (9)
≥Times for when used along with the optional
battery pack are in parentheses.
≥To change the LCD brightness (➡ page 31).
∫ To confirm the battery charge
When the unit is on and powered by the battery
pack
Press [DISPLAY].
The battery display appears on the LCD for a
few seconds to show the approximate remaining
charge.
Full
(Appears automatically when there is
a few minutes of charge remaining.) ----------}
≥Press [RETURN] to clear the on-screen menu
icons.
∫ If the unit is not to be used for a
long time
≥Detach the battery pack. (Even if the unit is off,
it still uses some power. This can drain the
battery completely and lead to a malfunction.)
≥Recharge the battery pack when you are
ready to use it again.
LCD off
0 (factory
i5
preset)
2 (6) 1.5 (4.5) 3.5 (10.5)
2.5 (7.5) 2 (6) 8 (24)
D IO U T
AU
PT O
O
D EO
VI
SE
EA
R EL
SH
: PU
R D
C A
SD
DISPLAY
RETURN
Low Recharge
f
13
(Continued on the next page)