Transducer, Installation - Balluff BTL5-P1-M Serie Manuel D'utilisation Et Description Technique

BTL5-P/I1-M_ _ _ _-H/W-S32/K_ _/KA_ _
Micropulse Linear Transducer - Rod Style
3 Installation (cont.)
3.2

Transducer, Installation

The smallest permissible distance
between magnet ring and rod
mounting surface is shown in
Fig. 3-2.
The transducer has a M18×1.5 or a
3/4"-16UNF thread for mounting.
The sealing is carried cut with the
O-ring supplied at the flange facing.
Important Installation Notes:
The contact surface of the trans-
ducer must be completely con-
tacted by the mounting surface.
The O-ring supplied must make a
perfect pressure seal, i.e. the
bevel for the O-ring must be con-
figured exactly as shown in
Fig. 3-3.
When tightening the transducer,
do not exceed a tightening torque
of 100 Nm.
For horizontal mounting of trans-
ducer with stroke lengths greater
than 500 mm, the pressure tube
should be supported or attached
at its end.
When installing in a hydraulic
cylinder, do not allow the magnet
ring to rub against the pressure
tube. The bore diameter in the
piston and cylinder rod should be
at least 13 mm.
0.2 A
2.4 +0.4
A
A
45° ±5°
3.2
Bevel for O-ring,
view A
Fig. 3-3: Threaded hole for mounting the BTL with O-ring
4
english
BTL5...-K05
21
0.5
35
0.5
BTL5...-KA05
43
ca. 20
0.5
BTL5...-S32
43
ca. 12
Fig. 3-2: Transducer BTL5...H/W..., Dimensions
min. 25
max. 2
A
26 +1
0.2 A
Threaded hole
Bevel for O-ring,
M18×1.5 per
view B
ISO 6149
O-ring 15.4 × 2.1
Damping zone
H: 40
(unusable area)
W: 2"
Nominal length
= stroke
Magnet
Blind hole
H: M18 x 1.5
W: 3/4"-16UNF
25
Mounting surface
Damping zone
H: 40
(unusable area)
Nominal length
W: 2"
= stroke
Magnet
Blind hole
H: M18 x 1.5
W: 3/4"-16UNF
25
Mounting surface
Damping zone
H: 40
(unusable area)
Nominal length
W: 2"
= stroke
Magnet
Blind hole
H: M18 x 1.5
W: 3/4"-16UNF
25
Mounting surface
min. 25
45°±5°
max. 1.5
A
B
B
3.2
2.6
Threaded hole
3/4"-16UNF per
SAE J475
O-ring 15.3 × 2.4
60
Blind hole
M4 ×
4/6 deep
Ø 65
60
Blind hole
M4 ×
4/6 deep
Ø 65
60
Blind hole
M4 ×
4/6 deep
Ø 65
26 +1