Setup - Honda HRX537VYE Manuel Du Propriétaire

SETUP

UNPACKING
Remove all the cardboard from around the handlebar.
HANDLEBAR SETUP
1. Turn the handlebar adjust knobs [1] 90 degrees into the unlock
position [2].
2. Move the handlebar into the mowing position so that the locating
pins align with either the upper, middle, or lower holes on the
handlebar mounting brackets.
3. Turn the adjust knobs 90 degrees into the lock position [3] and the
pins will snap into the holes and lock into position.
GRASS CATCHER ASSEMBLY
1. Slide the grass catcher frame [1] into the grass catcher [2] and
install the plastic clips [3] as shown.
[1]
[3]
4
[1] (2)
[2]
[2]
2. Lift the discharge
guard [4] and install
the grass
catcher [2].
ENGINE OIL
The mower is shipped
WITHOUT OIL in the engine.
[3]
Add enough SAE 10W-30 API
service category SJ or later oil
to bring the oil level between
the upper limit [2] and lower
limit [3] marks on the dipstick
[1] as shown.
Refill amount: 0.35 ~ 0.40 L
Do not overfill the engine
with oil. If the engine is
overfilled, the excess oil may
get transferred to the air
cleaner housing and air filter.
FUEL
Refer to page 7.
BEFORE USING YOUR LAWNMOWER
Before using the lawnmower, all mower operators must read the
following chapters:
• SAFETY INSTRUCTIONS (page 2)
• CONTROLS (page 5)
• PRE-OPERATION CHECKS (page 6)
• OPERATION (page 10)
• MAINTENANCE SCHEDULE (page 13)
ENGLISH
[4]
[2]
[1]
[2]
[3]