Error Codes - OK. OWM 16222 A3 Mode D'emploi

Inlet filter
Fig. 12
Caution!
• Close the water supply!
• After cleaning, always make sure that the water hose is properly installed and no water
leaks.
Filter at the tap
Clean the filter if there is an insufficient flow of water when the water tap is open.
• Unscrew the supply hose from the water tap.
• Wash the inlet filter under running water.
• Reconnect the supply hose.
Supply filter at the washing machine
Clean the filter regularly, approximately every three months.
• Unscrew the supply hose on the back of the unit.
• Clean the filter with a small brush.
• Reconnect the supply hose.

ERROR CODES

Problem Cause
Err1 • Lock - error
Err2 • Drainage error, water is not fully
drained within 6 minutes
Err3 • Temperature sensor error
Err4 • Heating error
(Appears at the end of a cycle)
Err5 • Water level not reached after 8
minutes.
• Drain hose is self-syphoning.
Err7 • Motor - error
Err8 • Water protective level - error
Unb • Unbalanced load - error
PAUS • Modus after power interruption
IM_OWM16222A3_170811_V06_HR.indb 21
21
Solution
• Shut the door properly
• Clean pump filter
• Check drain hose installation
• Contact the After sales service
• Contact the After sales service
• Make sure that tap is fully opened and water
pressure is normal
• Check drain hose installation
• Contact the After sales service
• Contact the After sales service
• Check and balance laundry load in the drum
• Reduce the load
• When power is reconnected, press the Start/
Pause button for program to continue
EN
11/8/17 4:17 pm