Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
may result in considerable danger to the user.
The use of unauthorized parts or failure to follow the maintenance instructions may result in injury
or damage.
8. Remarks
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above
3.3- Safety warnings regarding the use
1. Become familiar with the controls and the proper use of the product.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use
of the product by a person responsible for their safety.
IV- GETTING STARTED
Before any intervention on the product, remove the batteries from its compartment.
4.1- Unpacking
- Remove product from its packaging.
- Check that product and accessories are not damage.
- Content: 1 timer unit; 1 reducer connector; 1 quick connector; 1 manual
4.2- Inserting or replacing the battery
- Remove battery compartment (8), by firmly pulling it.
- Insert 2x1.5V alkaline batteries type LR6 / AA (not included) respecting the polarity.
- Replace the battery compartment (8), by firmly inserting it into main body.
4.3- Assembly
1- Connect tap connector (2) (or the reducer (1)) to your water tap. Firmly screw it by hand
Note: do not use any tool to avoid damaging the tap connector.
2- Screw the quick connector (7) to the thread on main body lower part.
3- Connect the hose of your terminal to the quick connector (7).
Remarks:
- Install the timer vertically to avoid water dripping or entering the battery
compartment (8).
- Do not force the quick connector (7) by for example pulling on the hose.
- Ensure that the metal filter (a) is properly fitted inside the tap connector (2).
Do not use the water timer without the metal filter (a).
4.4- Start up
4.4.1- Programming
- Set the run time adjustment knob (4) to the desired value according to your needs (1, 3, 5, 10, 15,
20, 30, 60, 90 or 120 minutes).
- Set the frequency adjustment knob (6) to "Reset". Make sure that the operating indicator light (3)
is flashing red.
- Then set the frequency adjustment knob (6) to the desired value (1, 2, 3, 4, 6, 8, 12, 24, 48, 72
hours or 1 week) while the operating indicator light (3) flashes red.
8
17
Page
/
Publicité
Table des Matières
