Access To The Domestic Network And Internet - Gewiss CHORUS GW 16 972CB Manuel De Programmation

Access to the domestic network and Internet

When THERMO ICE has not yet been configured to access the server and the domestic network, you must
configure the network parameters via the THERMO ICE app.
After activating the Wi-Fi radio module via parameter "P40" of the local thermostat menu, the device's AP
(Access Point) mode must be activated via parameter "P39" (see the "Parameter settings" paragraph); in
this mode, the device has its own wireless network with unique SSID "GW_THERMOICE_YYXX" (YYXX is
the unique device ID), to which the mobile device used for the configuration must connect.
Once the AP mode has been activated, the thermostat restarts and "AP:XX" appears on the display, where
XX are the last two characters (numbers and/or letters) that appear in the network name created by THERMO
ICE.
The thermostat remains in this condition while it waits for the configuration.
To continue with the configuration, use the mobile device to connect to the "GW_THERMOICE_YYXX"
network generated by the thermostat, then deactivate the data network of the mobile device, launch the
THERMO ICE app, and enter the following values on the access page:
e-mail:admin@admin.it
password: admin
Press the LOGIN button key. The page for configuring the network parameters will appear. Enter all the
data relating to the domestic wireless network to which THERMO ICE will connect in order to communicate
with the remote server (via the Internet).
USER INSTRUCTIONS
47
E
N
G
L
I
S
H