Mitsubishi Diamond Scan 52 Manuel Utilisateur page 9

Tilt / swivel base fixing,
removing
Fixing
This product consists of the monitor and the tilt / swivel base.
When fixing the tilt / swivel base to the monitor, please follow the steps
below.
• Push the hooks of the tilt / swivel base into the holes at the bottom of
the monitor.
• Then slide the tilt / swivel base forward.
• Then the latch above the tilt / swivel base engages it is secure.
Removing
Please removing the tilt / swivel base when transporting for repair.
• Push down the latch of the monitor and pull out the tilt / swivel base.
• Slide backward the tilt / swivel base from the front of the monitor.
• Pull out the tilt / swivel base from the holes of the monitor.
1. For correct use of monitor, completely attach tilt / swivel base to
the monitor.
2. To avoid self injury or damage to the monitor, attach and remove tilt /
swivel base with care.
01_english
English-5
5 24/5/01, 3:23 pm