JBM AET-R1B1 Guide D'utilisation page 12

EXPLANATION OF MARKS OR SYMBOLS
The following symbols may appear on the manual,
Infrared Thermometer and its accessories.
MUST OBSERVE
Means Obligatory with detailed items
expressed in words or figures within
or beside the mark. Left one means
General Compulsory.
Follow instructions for use.
IMPLICATION OF SYMBOL
Type-BF applied part.
Caution: Consult accompanying
documents.
Do not dispose this product as
unsorted municipal waste. Collection
of such waste separately for special
treatment is necessary.
Transport package shall be kept
away from rain.
Transport package shall not be
exposed to sunlight.
Indicates correct upright position of
the transport package.
Contents of the transport package
are fragile therefore it shaII be
handled with care.
Indicates temperature limits within
the transport package shall be stored
and handled.
Non-ionizing electromagnetic
radiation.
Do not roll.
Lot number.
Production date.
MAINTENANCE, STORAGE AND CALIBRATION
Maintenance
1. Remove any stains on the body with a soft and
dry cloth.
2. Clean the probe tip as follows: very gently wipe
the surface with a cotton swab or soft cloth mois-
tened with clinical alcohol, after the alcohol has
completely dried out, you can use the thermome-
ter. If the probe tip is damaged, please contact
the maintenance center.
3. Don't wash with water or detergent containing
abrasive or benzene.
4. Do not immerse in liquids.
Storage
1. The device must not be stored or used at an ex-
cessively high or low temperature or humidity, in
sunlight, in association with un electrical current
or in dusty locations.
2. Remove the battery if non-use for a long time.
Calibration
This thermometer is calibrated at the time of manufac-
tured. If the thermometer is used according to the ins-
truction, periodic recalibration is not required. If at any
time you question the accuracy of the measurement,
contact the retailer immediately. Don't attempt to modi-
fy or reassemble the thermometer.
WARRANTY
1 year warranty from the date of purchase, excluding
errors made by the user below:
1. Error produced by unauthorized disassembly
and modification.
2. Error produced by a fall during use or transport.
3. Error produced by use far from the instructions
described in the manual.
· 12 ·
The device should not be used after
the end of the shown or the day.
Protected against solid foreign
objects of 12.5mm dianeter and
greater. protected against vertically
falling water drops when the device
is tilted up to 15°.
Manufacturer.
CE Mark: conforms to essential
requirements of the Medical Device
Directive 93/42/EEC.
Authorized Representative in the
European Community.
REF. 53794