SUEZ Sievers InnovOx Manuel D'utilisation Et De Maintenance page 21

To ensure proper operation and protect against injury, do not operate the
Analyzer with the covers off or the door open.
Any operation requiring access to the inside of the Analyzer, including
installation of maintenance items, could result in injury. To avoid potentially
dangerous electric shock or burning, turn off power and disconnect from the
power supply before opening the Analyzer. Use caution when touching any
electronic components.
If a mounting stand accessory is used with the Analyzer, the mounting stand
must be bolted either to a wall or the floor prior to installation of the Analyzer.
The pressure of the compressed gas at the Analyzer's gas inlet must not
exceed 6.8 Bar (100 psig). The pressure of compressed gas at the blowback
gas inlet on the Filter Panel accessory must not exceed 2.7 Bar (40 psig). Use
only dry, oil-free air or nitrogen.
If the IP56 accessory is used with the Analyzer, do not operate the Analyzer
without the filter installed on the reactor cooling air inlet.
Before analyzing a new sample, refer to Chapter 3, Interferences, for
information on potential interferences and their effect on the Analyzer.
When handling components that contain sample, standards, waste solution, or
reagents, wear eye protection and gloves.
The display screen may contain mercury and may be considered hazardous
material in your local area. Dispose of this items in accordance with federal,
state, or local government regulations.
SUEZ © 2018
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
21 / 271 DLM 68100-12 FR Rev. C