Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
CAUTION:
1.
SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery charger.
2.
Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using
battery.
3.
CAUTION – To reduce risk of injury, charge only MAKITA rechargeable batteries. Other types of batteries may burst causing personal
injury and damage.
4.
Non-rechargeable batteries cannot be charged with this battery charger.
5.
Use a power source with the voltage specified on the nameplate of the charger.
6.
Do not charge the battery cartridge in presence of flammable liquids or gases.
7.
Do not expose charger to rain or snow.
8.
Never carry charger by cord or yank it to disconnect from receptacle.
9.
After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull by plug rather than
cord whenever disconnecting charger.
10. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
11. Do not operate charger with damaged cord or plug — replace them immediately.
12. Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a
qualified serviceman. Incorrect use or reassembly may result in a risk of electric shock or fire.
13. The battery charger is not intended for use by young children or infirm persons without supervision.
14. Young children should be supervised to ensure that they do not play with the battery charger.
15. Do not charge battery cartridge when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F).
16. Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.
17. Do not allow anything to cover or clog the charger vents.
Charging
1.
Plug the battery charger into the proper AC voltage source. Charging light will flash in green color repeatedly.
2.
Insert the battery cartridge into charger until it stops adjusting to the guide of charger. Terminal cover of charger can be opened with
inserting and closed with pulling out the battery cartridge.
3.
When the battery cartridge is inserted, the red charging light will light up and charging will begin with a preset brief melody sound
coming out for assurance as to which sound will come out to notify the completion of charging.
4.
With finish of charge, the charging light will change from red one to green one and the melody sound or buzzer sound (a long beep)
comes out to notify completion of charge.
5.
Charging time varies by temperature (10°C (50°F) – 40°C (104°F)) that battery cartridge is charged at and conditions of the battery
cartridge, such as a battery cartridge which is new or has not been used for a long period of time.
6.
After charging, remove the battery cartridge from charger and unplug the charger.
Changing melody of completed charging
1.
Inserting the battery cartridge into charger brings out last preset brief melody sound of completed charging.
2.
Removing and re-inserting it within five seconds after this action makes the melody sound change.
3.
Every time removing and re-inserting it within another five seconds after this, the melody sound changes in order.
4.
When the desired melody sound comes out, leave the battery cartridge being inserted and the charge will begin. When a "short beep"
mode is selected, no completed charging signals comes out. (Silent Mode)
5.
With finish of charge, the green light remains lit with the red light going out and the melody sound preset at the insertion of battery
cartridge or buzzer sound (a long beep) comes out to notify completion of charge. (In selected silent mode, no sounds come out.)
6.
Preset melody sound remains stored even when the charger is unplugged.
Voltage
Number of cells
Ni-MH Battery cartridge
Voltage
Number of cells
Li-ion Battery cartridge
NOTE:
• The battery charger is for charging Makita-battery cartridge. Never use it for other purposes or for other manufacturer's batteries.
• When you charge a battery cartridge which is new or has not been used for a long period of time, it may not accept a full charge until
after discharging it completely and recharging a couple of times. (Ni-MH battery only)
6
9.6 V
12 V
8
10
B9017A
—
BH9020/A
—
—
BH1220/C
—
—
BH9033/A
—
—
BH1233/C
14.4 V
18 V
4
5
BL1415
BL1815
—
—
14.4 V
Capacity (Ah)
12
—
1.7
—
2.0
BH1420
2.0
BH1427
2.7
—
3.3
BH1433
3.3
14.4 V
18 V
8
10
—
—
BL1430/A
BL1830
Charging time (Minutes)
20
20
15
20
30
22
Capacity (Ah)
Charging time
according to
(Minutes)
IEC61960
1.3
15
3.0
22
Publicité
Table des Matières
