Vollrath MIRAGE Manuel De L'opérateur page 5

t
roubleShooting
Problem
The unit is on, but not heating.
The digital display lights are flashing.
The unit suddenly stopped working.
Flashing Message (F code)
Add Pan
(Add Pan)
Bad Pan
(Bad Pan - F9)
TOO HOT
BAD FLO
(Bad Flow - F8)
HT SNC
(Heat Sync - F4)
HT TH
(Heat Therm - F5)
HOT
(Too Hot - F2)
S r
ervice and ePair
There are no user serviceable parts within this appliance. To avoid serious injury or damage, never attempt to repair the induction range or replace a damaged
power cord yourself. Do not send units directly to the Vollrath Company. Please contact the qualified professional repair service listed below.
When contacting the Authorized Professional Service Center, please be ready with the model number, serial number, and proof of purchase showing the date
the unit was purchased.
It might be caused by
The inset may be too small or may not be induction-
ready.
No induction-ready inset in unit.
The unit may be too close to an external heat source
or the air intake may be restricted.
The overheat-protection feature may have activated.
It might be caused by
No inset has been detected on the induction
retharmilizer.
The inset may be too small or is not a Vollrath
induction-ready inset.
The overheat-protection feature may have activated.
The unit may be too close to an external heat source
or the air intake may be restricted.
The overheat-protection feature may have activated.
The overheat-protection feature may have activated.
No defect. Indicates the heating area is hot after a
heating cycle has completed.
The overheat-protection feature may have activated.
VOLLRATH Induction Repair Service • 1-800-825-6036 (USA) or www.vollrathco.com
Course of Action
Make sure the inset is induction ready. See the
FUNCTION and PURPOSE of this manual.
Place induction-ready inset in the unit.
Relocate the unit away from any external heat
source. Clear any obstructions to the air intake.
Remove inset. Let cooking surface cool.
Course of Action
Place induction-ready inset in the heating area..
Turn the unit "OFF" and "ON". Use a Vollrath
induction-ready inset. See the FUNCTION and
PURPOSE of this manual.
Remove cookware. Let cooking surface cool. Clear
any obstructions to the air intake.
Relocate the unit away from any external heat
source. Clear any obstructions to the air intake.
Remove inset. Let cooking surface cool. Clear any
obstructions to the air intake.
Remove inset. Let cooking surface cool. Clear any
obstructions to the air intake.
Restart with inset in correct location. Allow time for
the heating area to cool. (about 5-10 minutes)
Remove cookware. Let cooking surface cool. Clear
any obstructions to the air intake.
O
peratOr
5
' M
s anual