Pan & Tilt Adjustments; Power Supply Connections - Eneo MPD-72M2812M0A Guide D'installation Rapide

Optional mounting accessories
For information on optional mounting accessories please visit the eneo website at www.
eneo-security.com.
CAUTION: In the case of installation with Flush/ Surface/ Tilted
mount, IP protection rating is not guaranteed.
If power/video connectors are exposed to water or rain, separate
protection shield is essential.
Pan & Tilt adjustments
1. Pan limit: Pan is limited to +/- 173°. Do NOT force to rotate the gimbal over the
limit to prevent from the internal damage.
2. Tilt limit: Tilt is limited to 25° min ~ 90° max. with reference to the ceiling when
the inclination of camera module is 0°, that is, the image is aligned horizontally.
3. Rotation limit (Horizontal image alignment): Rotation is limited to +/- 95° max.
If CVBS video is enabled through ANALOG OUT0 or Sub-out port, WDR and 3D-NR
i
functions are disabled in all video outputs.It should be considered when installer adjusts
the video with installation monitor via CVBS video signal.
8
CAUTION:
Extreme care should be taken NOT to scratch the bubble dome
surface while the camera installing or adjusting.
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area.
Tighten enough the dome cover fixing screws so that there
should be NO gap between Lens hood and clear bubble to avoid
the light inflow from IR LEDs.

Power supply connections

Make sure the power is removed before the installation. Camera can work with either
24VAC or 12VDC, dual voltage power. Primary and secondary grounds are completely
isolated to avoid the possible ground-loop problems.
SDI output (Yellow)
Analog output (Black)
Power ( 24VAC/12VDC)
i Please use the cable as provided with camera. If camera cable is cut and re-wired,
the transmission distance of video can be reduced. Especially SDI cable should not be cut
because it requires detailed wiring job and affects the transmission distance.
EN
AC AC
AC(+): 24VAC/12VDC
(+) (-)
AC(-): 24VAC/GND
9