Part Names; Installation Instructions - Eneo MPD-72M2812M0A Guide D'installation Rapide

Part names

Flush mount
3-Axis gimbal
Lens
Safty wire
Dome cover
Bubble dome
Video output
Power supply connector
6
Power cable
OSD Menu control board
Power cable

Installation instructions

CAUTION: The camera's base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed.
2. Open the dome cover by loosening screws (4x12mm). Use the torque wrench
supplied.
• Place the dome base unit on pre-drilled position and fix it through using mounting
screws (4x30mm).
• Route the Power cable to the connecting place.
• In the case of installation with optional mounting accessories (Surface mount or
Tilted mount), the power cable should be fixed to the flush mount by using the
fixing screw and cable holder.
3. Set the camera's viewing angle.
4. Put the dome cover to the dome base unit and tighten the assembly screws.
Torque Wrench
EN
Plastic Anchor (6x30mm)
Mounting Screw (4x30mm)
7