• Cutting or extending the connecting cable of the interface results in defects in connecting. Do not bundle the connecting cable together with power supply

cord, indoor/outdoor connecting wire, and/or earth wire. Keep as much distance as possible between the connecting cable and those wires.

• The thin part of the connecting cable should be stored and placed where customers cannot touch it.

Room air conditioner

1) Fix the cable tie to the connecting cable at 270 mm from the edge of the insulation coating part. Attach the mounting cord clamp (medium) to the interface

side of the cable tie.

Mounting cord clamp (medium)

2) Remove the grille. (If the grille has been already installed)

3) Remove the electrical cover (1), (2).

Refer to 2-4. CONNECTING WIRES FOR INDOOR UNIT.

4) Slide out the indoor control board, and connect the connecting cable to CN105 on the indoor control board.

5) Remove the screw shown in the photo blow. Route the connecting cable according to the photo below. Fix the mounting cord clamp (medium), which has

attached to the connecting cable, with the screw.

6) Reinstall the indoor control board and the electrical cover (1), (2).

7) Reinstall the grille.

Fix the connecting cable at the prescribed position securely.

Incorrect installation may cause electric shock, fire, and/ or malfunction.